Fishing with a spinning fly. Flies for the spinningist
Are you a spinningist, but would you like to try fishing for a fly, because nothing is caught on the «iron»? Then you will only need a light spinning, a small transparent water ball, a fishing line with a diameter of 0.20 to 0.22 mm and two or three wet flies. The advantage of such equipment is that you do not need to practice for a long time in casting with a fly fishing rod. The cargo will be a water ball, which can be filled with water to ensure long-range casting of the fly. Do not throw the bait directly to where the trout is standing, but let the current carry the water ball to the place where fishhunts for nymphs or grabs insects from the surface of the water. When biting, the cutting should not be too hard, because the fish itself is detected under the load of a water ball.
Installation instructions for fly fishing equipment
First, a transparent water ball is tied with a «palomar» knot
towards the end of the main line.
 At a distance of 15 cm from the water ball, the first side leash is tied to the main fishing line. |
 To do this, take a piece of fishing line with a length of 30 to 50 cm of the same diameter, which is folded in a loop near the main fishing line. |
 Then one of the ends is wrapped five times around the loop and the main fishing line. |
 In conclusion, the fishing line is threaded through the loop back and the knot is tightened tightly. |
 The extra ends of the fishing line are cut off. |
 The side leashes are shortened to a length of 15 cm and above the first leash, two others are tied to the main fishing line. |
 Wet flies are tied to the ends of the side leashes with an «improved clinch» knot, and the equipment is ready. |
An amazing knot for tying side leashes, in which no fish will come off.
Snap-in elements.
Share this page in the social. networks or bookmark:
bookmark this page
